Bl Working

I did this yesterday, walking up and down the aisles aimlessly, trying to figure out how to drill that 20” hole in the hinge in a way that would minimize screwing it up. It came to me in the plumbing section, believe it or not, when I spotted the different sized hose clamps.

This is the result of that brainwave.

Seeing the hose clamps gave me the concept of how to fix the drill. It wasn’t a stretch of the imagination to come up with the bed, it is just a 1x8 hunk of pine with a couple of 1x2’s used as skates and two more used as guides. A thick coat of LeeValley’s “Waxilit” made the whole thing slide back and forth with minimal force.

I still have to fine-tune the position and height of the drill and make a couple of more clamps to hold and position the hinge. Once I get that done I can take it for a test drive.

The comments from Bill and Steve in response to my last post where I asked for some ideas regarding how to handle this were good, and I appreciated the thought they put into their suggestions. The problem I had was that they both involved cutting up the hinge. Both ideas would work, but both would also take the challenge out of it and frankly, guys, where’s the fun in that?

I’ll let you know how things work out.

Peace,

Mitchell

AN UPDATE!

I produced this jig to minimize screwing up my mahogany hinge while drilling a 1/4" diameter hole through its entire 20" length.

I screwed it up.

Peace.